Irricad Link - Large Negative Z values

Discussions about hydraulic design.
Post Reply
turbofergy
Posts: 28
Joined: Mon Jul 18, 2016 5:38 pm
Company: Ferguson Irrigation Solutions and Techno
City / Town: Bundaberg

Irricad Link - Large Negative Z values

Post by turbofergy » Tue May 28, 2019 11:44 am

Hello All

Setting out a block in Link. When i put in a cut pipe for a sub main the nodes are getting very large negative Z values (-1000000.00). I am not sure where they are coming from. When i look at the 3D DEM the heights are are all correct. is there a way to correct this

Regards

Kyle

User avatar
jovivier
Site Admin
Posts: 531
Joined: Thu Mar 12, 2009 2:57 pm
Company: LVL
City / Town: Blenheim
Location: Lincoln, New Zealand
Contact:

Re: Irricad Link - Large Negative Z values

Post by jovivier » Tue May 28, 2019 5:24 pm

Hi Kyle,

In IRRICAD Link the Z value may not be set (-100000.00) or may be set to 0.0 for IRRICAD items. However, if elevations are present and able to be used in the hydraulic design then the "Elevation" is specified in the Object Info dialog as follows:-
Elevation.png
Elevation.png (7.81 KiB) Viewed 83 times

The IRRICAD Team

Post Reply