If Hydraulic Gradeline does not work in Link

FAQs and Tips specific to IRRICAD Link
Post Reply
User avatar
Site Admin
Posts: 612
Joined: Thu Mar 12, 2009 2:57 pm
Company: LVL
City / Town: Blenheim
Location: Lincoln, New Zealand

If Hydraulic Gradeline does not work in Link

Post by jovivier »

If you are not seeing the Hydraulic Gradeline in IRRICAD Link after actioning the tool, and can see the "HGL" command in the command line then this issue is caused by a missing on non-registered OCX control.

1. First check that the TeeChart file is present in your installed Irricad folder, commonly located at C:\Program Files\Irricad\Irricad Link xxxCAD.
If the ocx file is not present you should find it in your anti-virus quarantine where it can usually be restored from and an exclusion/exception set in your anti-virus for this file. If you cannot restore it download the file from http://www.irricad.com/irricad/download ... 201664.zip, save the zip file to your hard-drive, and unzip the contents into your installed Irricad Link folder.

2. If the TeeChart file is present in the Irricad folder then the cause is that it did not register on your computer upon installation. Reasons for this could be limited privileges when installing IRRICAD or another program interfering during the installation. (It is always a good idea to turn off other programs and even your anti-virus software during the installation process).
You can register this file manually.

a. Log in as Administrator.
b. Run a Command Prompt by searching for cmd and then right-click on cmd.exe and select Run as Administrator.
A DOS window will open up.
c. Now type in cd C:\ <enter>
cd program files <enter>
cd irricad <enter>
cd Irricad Link xxxCAD<enter> - enter the correct CAD platform - i.e. AutoCAD or BricsCAD
(note type in the correct Irricad folder path name for where your Link version is installed)
regsvr32 TeeChart201664.ocx<enter>

It should tell you that TeeChart201664.ocx is now registered successfully.

Post Reply