Irricad

Hi yall,

I'm having to enter a few pressure regulators into our database. I've attached an example of the information for this product (Part # PRM10HFM). On page 33, there is a chart and i'm not sure which pressures/flow to add-do i add the psi for the discharge? or the inlet? I'd use the H=KQ^n +C ...

Hi Polivos,

Have you looked at the Settings->Snap->Cut Pipe Tolerance/Cut Pipe Length Factor?

Samantha

Thank you both for your help,

Hi ya'll,

Can someone tell me what i'm doing wrong please. Let me start from the beginning.Ok, first i get the spec sheet for the part(1" 2-way Electric Control PB1). On this spec sheet, there is usually a graph/chart that shows the relationship between PSI vs flow (attached ). I choose three ...

It worked thanks!

Awesome!!! Thanks,i appreciate it (and i'll for sure, make sure i use the right units).

Hi ya'll,

In reading the Irricad Database Editor manual (Utilities Menu), i learned that i can get help calculating these constants (K,n,C) by using the Curve Fit+Ctrl+T bar. So, after entering all my numbers into the minumun cells required,the data came out looking like the attachment. I'm sorry ...

Hi Jo,

I've placed our primer/glue into an assembly.However, we figured that for each assembly-we only use less than 1 (by formula,we figured we use an amount less than 1, let's say .088). When i try to put that amount in, there is a prompt that comes up and doesn't allow me to proceed with that ...

Hi ya'll,


I read the description of what the Tolerance % Above/Below is:

Tolerance % Above:
Enter the “Zone Pressure Tolerance % Above”. This indicates the upper limit of the pressure window that the tape is to operate in.

Tolerance % Below:
Enter the lower limit of the pressure window the ...

Thank you!

Untitled 1.odt

Hi Ya'll,

I've got a quick question.I know the Emitter Constant(constant k) for a tape is 0.159-but it's displayed in the Irricad database, as 0.601815. I know there is a conversion from metric, but i'm not completely understanding it. Can you help me with the formula and also ...

Can i get an email address to send an example to please?

Thanks!
Samantha

Hi yall,

Can one of you help me with the "official" procedure of how to import topo points from an Autocadd drawing? I've completed one successfully but i am not getting the same results with each drawing. First,i create a SaveAs of the original dwg (with the topo points) into a DXF format. Then,i ...

Hi Jo,

Can you please tell me what this means? Thanks,

Samantha

Thanks Jo, I tried it again while leaving the "Import as Polylines" unchecked and this solved it! Thank you so much,i appreciate it


Samantha

Thanks!

pic.jpg

Hi ya'll,

In one of my practice designs mimicking an actual design, I ran a Pressure Map. When I was done,I noticed that at the ends of the tape and at each color change (Pressure variation)-there is a difference in the tape line thickness. If you'll see in the attached picture, the line ...

Thank you!

Thank you!

Jo,

Actually, I tried each option in the drop-down list and none worked. Do I have any more options? Is there anything else that I can do on my end? Thank you in advance,

Samantha