Irricad

Hi everyone, I have a problem, when I create spray irrigation block, I get the sprayline oulets, but they do not appear sl_wetted_radii, this problem happens to me only with this sprinkler, because I have activated the configurations and with other emitters this does not happen, how can I To solve this, is there any configuration in the database?

thank you very much for your help

regards

Hi Miguel

If you cannot see the wetted radii, then I suspect that the parameter has not been set to create them. Under the Settings menu, select the tab "Irrigation Design Specific". Make sure that "Create Wetted Radii" is checked.

The layer to turn radii on or off for connected spraylines is SL_Wetted_Radii
The layer to turn radii on or off for unconnected spraylines is Outlet _Wetted_Radii

If you have set all of the above correctly and the radii still do not appear. Try a block with a different sprinkler. If this works, the radius information may not be in the database for the sprinkler that you are using. Search the IRRICAD help for "Nozzles" and you will find the steps to enter radius information into the database for an outlet/nozzle.

Graham

Thanks Graham, unfortunately the problem persists, I have made a new block with another sprinkler and if the diameter of wet appears, your help with regard to the configuration of the nozzles would be useful for me to appear wetted radius

Hi Miguel,

For sprayline outlets or normal outlets that are created without a wetted radii you can select the outlets or spraylines and use Tools|Create Wetted Radii. If the wetted radii do not appear check that a radius has been set in the database (constant and index) or alternatively you can overwrite the value has been entered in the Outlet or Sprayline dialog for the sprinkler radius.
Another possibility could be that the wetted radii colour is the same as your background colour so the wetted radii may actually be there but "invisible".