Irricad

Hello everyone.

I would like to know if there is a report in which I indicate the total losses of a zone, that is to say the loss that exists in the zone pipes and the laterals and losses of the valve, all in the same report, this To counteract the theory that losses should be less than 20% of the issuer's pressure.

example

VALVE 3

VALVE HEAD LOSS ZONE PIPES LATERAL

0.75 m 2.12 m 1.82 m

VALVE 4

VALVE HEAD LOSS ZONE PIPES LATERAL

0.72 m 2.02 m 1.65 m


Thank you very much

Hi,

Unfortunately that is not possible because of the way that the reporting currently works.

However, if we were to make some programming changes in the future we see the potential issues being:-
- the maximum lateral loss is not necessarily at the end of the block
- elevation change. Would you want the elevation change included or excluded from the totalled headlosses?

The IRRICAD Team