Irricad

¡¡Gracias por la respuesta!!

¡HOLA!
QUISIERA SABER COMO SIMULAR UN SISTEMA COMO SE MUESTRA EN LA FIGURA (RED DE SUMINISTRO POR GRAVEDAD)

SERÍA UN RESERVORIO AGUAS ARRIBA QUE SUMINISTRE PRESIONES ATMISFÉRICAS A DOS O MÁS RESERVORIOS AGUAS ABAJO.

HELLO!
I WOULD LIKE TO KNOW HOW TO SIMULATE A SYSTEM AS SHOWN IN THE FIGURE (GRAVITY SUPPLY NETWORK)

IT WOULD BE AN UPSTREAM RESERVOIR SUPPLYING TWO OR MORE DOWNSTREAM RESERVOIRS WITH ATMISPHERIC PRESSURES.

Here is a small generic example:- Water Source at the top of the hill set to 0m head. Pipeline with junctions at important contours (or a constant slope will be assumed) . Required outlet and nozzle at the bottom of the hill. GravityFeedSystemv15.zip Versions 15 and later can open this design. The ...

For a gravity system use a water supply as the water source. The "Design Head" and "Maximum Head " can be set to zero ( 0 ) in IRRICAD Versions 15 and later, or to a small positive head in older versions. Note that if the water source is expected to maintain some pressure or hei...

OK!
thank you for the informations.

Hello! I would like to know how to simulate a gravity system correctly. for example: - Water source: 125m - Piping with an inner diameter of 70.5 mm -Length: 401 m -Reservoir: 100 m What is the flow that arrives in the reservoir with a difference in level of 25 m. Which hydraulic item should I use t...

OK!
EXCELLENT
THANKS

Hello!
I would like to know how the head loss calculation located on the main line is done.
What is taken into account for the calculation?

Hello!
When will the new version be available for Ventral Pivot projects?

Hi!
Is there a way to model a center pivot in Irricad?

Hi!
Making automatic block divisions manually, but when I accept the conditions the emitters line is no longer aligned............and I need to keep the alignment to facilitate mechanization.
How can I force the alignment to remain in the division?

OK Jovivier!
I'll do what you told me here.........
Looking forward to the release of the new version.......Irricad 20.
And what other new features in version 20?
also nice if you can export DXF or DWG with elevation...

Hi!
Can I edit or reset the number sequence of the joins(nodes)?

OK!
Where do I find the advanced tutorial "Using a pump in a project".
Could you share the link?
thanks always for the guidelines.

How to make a hydraulic simulation of direct pumping from a deep well where the motor pump will be 60 m below the ground surface?
See attached schematic drawing.

OK!
Thanks.

Helo! I would like to better understand when to check or uncheck this box: Allow for Minor Losses

Helo!
I have a project with 29 operations, I would like to know the easiest way to direct the flows to the valves since the default execution time is 1 hour.
I changed the cycle time to 2 days, but it still didn't work.......

Hello Jovivier!
Perfect, now I get it.
Thanks again for your attention as always.