Irricad

Is there any way to create a legend for contours that I have created in a project i'm working on?

v11 of Irricad will be able to generate contours from spot heights, and will have much improve handling for elevation calculations. This is a quote from an earlier posted question & response as to importing elevation information. I have v.11 and would like to know how to make this conversion fr...

How to "short circuit" error message concerning "curved tapes"? I designed a tape block (user determined lateral direction); when I run zone design, the "curved tape" message for every tape lateral in the block! I'm going to have to trade my "clicking" finger ...

OOPS!
I meant to say without changing the units !

Thanks for the reply. I tried what you suggested and got the following result: changed unit to meters, then imported .shp file. Ran 3D (in report) and got what appears to be metric data. changed units to ft, data changed to ft. However, the values (in ft) seem to be very close to the values that I h...

Customer has supplied to me a .shp file with elevation data that was collected in meters. Is there I process whereby can convert the data to feet without calculating & changing every data point individually?

Is it possible to import an image saved from Google earth and re-size based on the measurement bar shown on the image?
If not, please advise as to how to obtain a scalable image that may be used as a "backdrop" over which to design a project that will be accurate as to scale.