Assign Zones to Water supplies

[Jim Phillips]

In a large design I am having trouble getting IrriCAD to select the zones I want for a given water supply. It works up so far then keeps defaulting the previous allocate zone to zero.
Is there a way to nominate in the "Assign Zones to System Flows" box to enter say Zones 1 - 30 on Water Supply 1 collectively rather than trying to nominate individually?

[jovivier]

Hi Jim,

There are two way to do this outside of selecting the water supply when selecting the zones to assign to a system flow.
For example if you have two water supplies and 25 system flows which are divided between the water supplies and a last system flow that requires both water supplies see the options below:-

1) Graphically
In Assign Zone to System Flows
Select water supply 1 and assign the required system flows in the following format: 1-5,12,20-25,26
The select water supply 2 and assign 6-11,13-19,26

2) in the Table
Use Other Management Options|Assign System Flows to Zones if you have already assigned your zones.
You can enter groups of zones by using the '-' before the number. Therefore a negative number is the start or end of a group of system flows and a positive number is a system flow number.
Against water supply 1 - In column B enter -1 and in column C enter -5. In column D enter 12. In column E enter -20 and in Column F enter -25. In Column G enter 26.
Against water supply 2 - In column B enter -6 and in column C enter -11. In column D enter -13 and in column E enter -19. In Column F enter 26.


The IRRICAD Team