cursor/plotting issues in design portion

If your question does not belong in any of the other forums, then this is the forum for you.
Post Reply
TGSSI2019
Posts: 2
Joined: Tue Apr 02, 2019 8:04 am
Company: Seacrest Services Inc
City / Town: west palm beach

cursor/plotting issues in design portion

Post by TGSSI2019 »

Cursor/plotting issues in design portion. Cursor seems to be jumping instead of free flow.
Top
User avatar
jovivier
Site Admin
Posts: 919
Joined: Thu Mar 12, 2009 2:57 pm
Company: Lincoln Agritech Ltd, IRRICAD Software
City / Town: Lincoln
Location: Canterbury, New Zealand
Contact:
Contact jovivier

Re: cursor/plotting issues in design portion

Post by jovivier »

This sounds like the snap mode could be set to "Snap to Grid". You can check this on the bottom right of your status bar in the "Snap" panel. Note that this should be set to "Connect" mode when drawing hydraulic items.

The IRRICAD Team
Top
Post Reply

Return to “Miscellaneous”