Allow for Minor Losses

marcioagr · Post by **marcioagr** » Sun Jun 13, 2021 9:18 am

Helo! I would like to better understand when to check or uncheck this box: Allow for Minor Losses

Post by **jovivier** » Mon Jun 14, 2021 2:55 pm

Dear Marcio,

This is explained in the manual, see Help|Help Topics - User Manual -> Advanced Topics -> Spraylines, Tapes and Minor Losses.

The IRRICAD Team

marcioagr · Post by **marcioagr** » Mon Jun 14, 2021 10:56 pm

OK!
Thanks.

aridzv · Post by **aridzv** » Fri Aug 06, 2021 6:13 am

Hi.
About micro sprinklers -
I went over the minor losses in the User Manual > Advanced Topics, and the Outlets Connections chapter in the database help, and just to be sure I've got it right, I have tow questions as shown in the attached screenshot:
thanks,
Ari.

Post by **jovivier** » Fri Aug 13, 2021 10:57 am

Hi Ari,

1. Yes, the headloss in the outlet connector is calculated as a friction loss based on the HL equivalent length (total length) and HL equivalent diameter (ID) entered in the Outlet Connector in the database.

2. Minor losses for connections to pipes (outlet connectors or laterals) are based on the minor loss calculation as explained in the manual. The Kd is only used for internal emitters (tapes/dripline).

The IRRICAD Team

aridzv · Post by **aridzv** » Sat Aug 14, 2021 5:41 am

Thanks!!

Irricad

Allow for Minor Losses

Allow for Minor Losses

Re: Allow for Minor Losses

Re: Allow for Minor Losses

Re: Allow for Minor Losses

Re: Allow for Minor Losses

Re: Allow for Minor Losses