In some situations you need to plot only part of your plan. How do you make the printed job look like it is a viewport looking at this section only?
To plot only a part of your plan, enable the “Keep Fills” check box when creating the Plot Layout. This places a fill under the legend area and outside of the border so that unwanted parts of your plan are not seen through these areas.
If no fill is appearing make sure:
• “Keep Fills” is checked in Draw|Plot Layout.
• Display “Fills” is enabled in Settings|Drawing Items.
• Try another template as you may have deleted the fills previously when editing the template.
• Remember to place fills in these areas when modifying or creating your own plot templates.
We hope you have found this helpful. If you have a tip you would like to share, please email your tip to Support@IRRICAD.com
14. PLOTTING PART OF YOUR PLAN
-
jovivier
- Site Admin
- Posts: 919
- Joined: Thu Mar 12, 2009 2:57 pm
- Company: Lincoln Agritech Ltd, IRRICAD Software
- City / Town: Lincoln
- Location: Canterbury, New Zealand
- Contact:
14. PLOTTING PART OF YOUR PLAN
You do not have the required permissions to view the files attached to this post.