Hi IrriCad Team,
I trust all is well.
I have a design which I made copies of an exploded management symbol and placed into three separate plot layouts for presentation purposes. After I had copied the management symbol I noticed that I had unconnected items in my design which were not there before and are shown in the image attached.
When I hit File, Repair it has created new valves in each of the irrigation areas on the management symbol only......
Can you please advise if you have the same outcome?
Thanks
Matt Binder
Management Symbol - Unconnected Items
-
Matt Binder
- Posts: 29
- Joined: Fri Mar 13, 2009 11:45 am
- Company: Think Water Riverland
- City / Town: Waikerie
- Location: Waikerie, Australia
- Contact:
Management Symbol - Unconnected Items
You do not have the required permissions to view the files attached to this post.
-
jovivier
- Site Admin
- Posts: 919
- Joined: Thu Mar 12, 2009 2:57 pm
- Company: Lincoln Agritech Ltd, IRRICAD Software
- City / Town: Lincoln
- Location: Canterbury, New Zealand
- Contact:
Re: Management Symbol - Unconnected Items
Hi Matt,
This is caused by a minor bug.
In the mean time in order to split up the management symbol and place the sections closer to the areas concerned you can still do that following the method outlined below:-
1) Remove the exploded management symbol and all its copies.
2) Regenerated the management symbol (Draw|Management Symbol).
3) Copy the management symbol.
4) Explode the copied one and move the sections where required.
This is caused by a minor bug.
In the mean time in order to split up the management symbol and place the sections closer to the areas concerned you can still do that following the method outlined below:-
1) Remove the exploded management symbol and all its copies.
2) Regenerated the management symbol (Draw|Management Symbol).
3) Copy the management symbol.
4) Explode the copied one and move the sections where required.