If Hydraulic Gradeline does not work in Standalone

[jovivier]

If you are not seeing the Hydraulic Gradeline in IRRICAD after actioning the tool then this issue is likely caused by a missing or non-registered OCX control.

1. First check that the TeeChart8 file is present in your installed Irricad folder, commonly located at C:\Program Files (x86)\Irricad\Irricad Pro xxx.
If the ocx file is not present you should find it in your anti-virus quarantine where it can usually be restored from and an exclusion/exception set in your anti-virus for this file. If you cannot restore it download the file from https://www.irricad.com/irricad/downloa ... Chart8.zip, save the zip file to your hard-drive, and unzip the contents into your installed Irricad folder.

2. If the TeeChart file is present in the Irricad folder then the cause is that it did not register on your computer upon installation. Reasons for this could be limited privileges when installing IRRICAD or another program interfering during the installation. (It is always a good idea to turn off other programs and even your anti-virus software during the installation process).
You can register this file manually.

a. Log in as Administrator.
b. Run a Command Prompt by searching for cmd and then right-click on cmd.exe or Command Prompt and select Run as Administrator. (Without running as administrator it will not work and you'll get an error message).

CMD-Admin.png

A DOS window will open up.
c. Now type in cd C:\ <enter>
cd program files (x86) <enter>
cd irricad <enter>
cd Irricad Pro xx<enter> - enter the correct name of the folder
regsvr32 TeeChart8.ocx<enter>

It should tell you that TeeChart8.ocx is now registered successfully.

The IRRICAD Team