Management Symbol Placement Issue in BricsCAD V23
Posted: Mon Feb 05, 2024 3:47 pm
In IRRICAD Link for BricsCAD v23 there is an issue placing the management symbol at large coordinates due to a change in BricsCAD. This has been partially fixed in the later versions of BricsCAD v23.
If you cannot see the preview of the management symbol to place it please follow the below recommendations:-
1. Upgrade your BricsCAD licence to BricsCAD v23.2.07.
2. Place the management symbol at a scale of '1' and, if required, adjust the size after placement (e.g., using the SCALE command).
An alternative to step 2 is:-
2) Use the “Specify on screen” scale option. Click to place the block, then enter the scale you require (e.g. 0.5) on the command line for both the X and Y scale.
The IRRICAD Team
If you cannot see the preview of the management symbol to place it please follow the below recommendations:-
1. Upgrade your BricsCAD licence to BricsCAD v23.2.07.
2. Place the management symbol at a scale of '1' and, if required, adjust the size after placement (e.g., using the SCALE command).
An alternative to step 2 is:-
2) Use the “Specify on screen” scale option. Click to place the block, then enter the scale you require (e.g. 0.5) on the command line for both the X and Y scale.
The IRRICAD Team