Pipe lengths not rounding if in assembly
Posted: Thu Oct 24, 2024 9:06 am
I'm using Irricad Link 21, and after the recent patch I have found that my materials reports are reporting the number of locations a pipe is found rather than rounding it to the lengths as set by the pipe fitting matching table. This only happens to pipe that is in an assembly. All mainline and zone pipe is reporting accurately.
For example,
I have 2" Sch 40 in flush assemblies and it will appear in the BOM as a quantity of 2.
But, if I have 5' of 2" Sch 40 in the zone or mainline, it will report it as "Lengths, 20' " to fulfill the desired rounding per the pipe fitting matching table.
For example,
I have 2" Sch 40 in flush assemblies and it will appear in the BOM as a quantity of 2.
But, if I have 5' of 2" Sch 40 in the zone or mainline, it will report it as "Lengths, 20' " to fulfill the desired rounding per the pipe fitting matching table.