14. PLOTTING PART OF YOUR PLAN
Posted: Fri Sep 09, 2011 5:25 pm
In some situations you need to plot only part of your plan. How do you make the printed job look like it is a viewport looking at this section only?
To plot only a part of your plan, enable the “Keep Fills” check box when creating the Plot Layout. This places a fill under the legend area and outside of the border so that unwanted parts of your plan are not seen through these areas. If no fill is appearing make sure:
• “Keep Fills” is checked in Draw|Plot Layout.
• Display “Fills” is enabled in Settings|Drawing Items.
• Try another template as you may have deleted the fills previously when editing the template.
• Remember to place fills in these areas when modifying or creating your own plot templates.
We hope you have found this helpful. If you have a tip you would like to share, please email your tip to Support@IRRICAD.com
To plot only a part of your plan, enable the “Keep Fills” check box when creating the Plot Layout. This places a fill under the legend area and outside of the border so that unwanted parts of your plan are not seen through these areas. If no fill is appearing make sure:
• “Keep Fills” is checked in Draw|Plot Layout.
• Display “Fills” is enabled in Settings|Drawing Items.
• Try another template as you may have deleted the fills previously when editing the template.
• Remember to place fills in these areas when modifying or creating your own plot templates.
We hope you have found this helpful. If you have a tip you would like to share, please email your tip to Support@IRRICAD.com