Irricad

How to "short circuit" error message concerning "curved tapes"? I designed a tape block (user determined lateral direction); when I run zone design, the "curved tape" message for every tape lateral in the block! I'm going to have to trade my "clicking" finger for new one if there is no solution. How to eliminate the "curved tapes"? How to get out of the error screen without having to run it all the way to the end?

Hi Mike, give me a call in the morning on this one.

Graham

NB. To draw curved tapes enable the "Polyline" check box. This means curved tapes will be drawn without a junction at each chnage of direction.