46. REPAIRING DESIGNS THAT WON'T OPEN
Posted: Fri Jun 14, 2013 10:24 am
You may be aware that if a design needs repairing you can use File|Repair. However what do you do if you cannot open the design?
You can repair the design before opening by:
1. Select File|New to load a clean untitled design.
2. Select File|Repair and then select the design to be repaired.
We hope you have found this helpful. If you have a tip you would like to share, please email your tip to Support@IRRICAD.com
You can repair the design before opening by:
1. Select File|New to load a clean untitled design.
2. Select File|Repair and then select the design to be repaired.
We hope you have found this helpful. If you have a tip you would like to share, please email your tip to Support@IRRICAD.com