Irricad

HI, how do I change the direction of a valve stub? I want this Valve stub to go to the left instead of the right.
This is a drip tape sub main zone pipe.

Hi
I suggest you thoroughly read the program user guide.
You can only do this in tape & spray block entities  . For example, you can do the following:
-Modify:change & click on block entity & click on block & click on control valve properties position & change start to end & etc.

Hi,

Internal rules determine which side the valve stub is drawn on. This looks to be the opposite side to the longest 1st lateral segment (the side of the closest edge). You can achieve a different result by selecting the opposite edge of the block when determining lateral direction though this is only the case if the submain in is the Center (as the submain position also moves with the other options). If the valve is not on the side you require highlight the valve and move it to the required position.

Thanks for the help!