Irricad

Hello all,

I can't figure out why Zone 2 (the small black diamond) in the screen shot shows 0 gpm. All valves and outlets are connected, and each of the other 3 zones are correct. I'm sorry I don't have more information at this time; I'm not sure what I'm missing.
I'm am relatively new to Irricad, any and all feed back is much appreciated.

Thanks,
Anthony

Hi Anthony,

I can't actually see if it says 0 USgpm in the black diamond or 0.0. However here are some thoughts:

- Rounding could be the issue - how large is the flow? Is it smaller than 0.1? This could be the cause if the flow is shown as 0.0 on the symbol, as only one decimal place is displayed.

- If this zone was added after an initial Zone Design, or was changed after designing the zones, you may need to re-run Zone Design before getting an updated management (Version 13)

- If you are running Version 13 have you installed the lastest patch V13.20?