Page 1 of 1
INPUT 82
Posted: Wed Feb 25, 2015 5:01 am
by Miguel_l_e
I get this message and valves too large
"Warning, coordinate range too large please correct and then run compress"
help
Re: INPUT 82
Posted: Wed Feb 25, 2015 9:46 am
by Dan Crosby
Hi Miguel,
You will get this message in one of two situations, usually after importing data. It appears when you have entities that are more than approximately 12.5km apart in your design. Sometimes when importing DXF/DWG there is some 'junk' far removed from your area of interest - View|Zoom All will show this. In that case, select and delete the 'junk' then run File|Compress.
(Note, it is sometimes easier to first select all the entities you do want to keep, then use Modify|Invert Selection to select everything you want to get rid of).
Alternatively, your design may legitimately be larger than ~12.5km in which case you can ignore this message.
Regards,
Dan
Re: INPUT 82
Posted: Fri Feb 27, 2015 1:08 am
by Miguel_l_e
I did zoom all, but I can not find any junk on Irricad or the dxf file, besides Valve size becomes too large.
thanks for answer
Re: INPUT 82
Posted: Fri Feb 27, 2015 9:57 am
by jovivier
Miguel,
For priority Version 14 support you can contact your local IRRICAD distributor. They may wish to see your design to help locate the items, which could be located on layers that are currently turned off. Once these have been removed and
File|Compress has been run resize the symbols to a different size and then back to the correct size.
See also the Support FAQ Forum for the warning message
http://www.irricad.com/phpbb3/viewtopic.php?f=17&t=420.