Zone flushing report
Posted: Wed Feb 25, 2015 7:05 pm
Hi All,
I have brought this up with you recently Jo but thought I would also post it to the forum for other peoples input.
With the Zone Flushing V13 report (which I think is a great tool) only a single virtual manifold or actual manifold can be analysed at once within each zone area and the manifold number to be analysed needs to be identified and then input into the Zone Design Configuration table which all takes time.
I would prefer to be able to select the Zones I wish to run Flushing analysis on and have Irricad analyse every manifold (as if each being flushed one at a time vs all at once) so I can then look through the report and inspect all the manifolds quickly and identify any problem areas.
I believe that this could save a lot of time and make this a more practical report.
I have brought this up with you recently Jo but thought I would also post it to the forum for other peoples input.
With the Zone Flushing V13 report (which I think is a great tool) only a single virtual manifold or actual manifold can be analysed at once within each zone area and the manifold number to be analysed needs to be identified and then input into the Zone Design Configuration table which all takes time.
I would prefer to be able to select the Zones I wish to run Flushing analysis on and have Irricad analyse every manifold (as if each being flushed one at a time vs all at once) so I can then look through the report and inspect all the manifolds quickly and identify any problem areas.
I believe that this could save a lot of time and make this a more practical report.