Irricad

It would be very helpful to have information of the zone areas in the reports (ie. area of influence of a control valve) along with the hydraulic data (Flow and pressure).

Hi,

Are you using the Zone|Area tool or the Irrigation Block tools? If so, information relating to the Area can be found in Reports|Management Reports.

Or do you mean a design report similar to the example below?

Hello,
Further to this it would be good if you could make your own customized report. I often produce a report in Excel similar to your example, but also include things such as No. of Outlets, Drip Line metres, etc.

The reports are customisable via the ReportEditor executable in your installed IRRICAD folder. However, report editing can be quite complex and involved, and there is limited written help.
For small changes we are happy to do these for you as time permits. We have customised many reports over the years and it is possible that we already have a report that includes the information you require.

The example report mentioned in the above post can be downloaded from http://www.irricad.com/irricad/download ... BLE872.zip .
A Control Valve report including the number of emitters, zone flow, upstream valve pressure, required valve pressure, and min/max allowable emitter pressures can be downloaded from http://www.irricad.com/irricad/download ... LVESUM.zip .
Save the zip file to your hard-drive and extract the FPC file to your IRRICAD \Reports folder, commonly located in C:\Program Files (x86)\AEI Software\Irricad Pro 14\Reports.

If you require other customised reports please email.

Hi Jo,

Thanks.