Page 1 of 1
CROSSHAIRS AT 45 DEGREES
Posted: Thu Oct 19, 2017 6:49 pm
by Jim Phillips
My crosshairs suddenly went from 90 degrees on the screen to 45 degrees and acted orthographically. how do I turn this off?
Re: CROSSHAIRS AT 45 DEGREES
Posted: Fri Oct 20, 2017 8:18 am
by Dan Crosby
Hi Jim,
I'm not sure about the cursor change - but it sounds like you've accidentally toggled Ortho mode On.
Check your Drawing options:
Ortho.png
It is also possible that Ortho mode is on, but doesn't show in the Settings. With the the default selection tool active, you can type 'OR' to toggle ortho mode on/off.
Dan
Re: CROSSHAIRS AT 45 DEGREES
Posted: Sat Oct 21, 2017 7:27 am
by Mike_M
Jim - Probably already been resolved by now. However if not, type "IM" with no other command active, that should revert it back to normal. I ran across this same situation a few times, likely by accidently typing IM!
I believe it is some kind of ISO view change command for VisualCad.
Re: CROSSHAIRS AT 45 DEGREES
Posted: Mon Oct 30, 2017 12:10 pm
by Jim Phillips
Thanks, Toggling and IM have worked a treat.