Irricad

Hello all
My name is Sam Rinaudo
I have Irricad 8 and when I tried to change an old design I could not add in the pipe size I wanted to. The only sizes available were the ones open at the time of the design. Can any body help on this matter.
Regards Sam

Hi Sam,

The pipe usages can be changed via the Database Editor - check that the pipes you want to use have the correct usage - L for connected lateral, Z for Zone, M for mainline. If this isn't the issue check that the database the design is using, via Settings|Irrigation Design - Specific, is the database that you are editing.

The IRRICAD Team