Bill of materials slope correction

[jabesmedeiros]

Hi. I´m working on a project with a very strong slope topography. As far as 40% slope. And the spraylines are aligned down the hill (not for my inttention but for the client's). The question is: Will Irricad consider the slope or 3D corrections for hydraulics or bill of materials calculations? Is it posible to have slope corrections taken in account? I have Irricad 14.16. Thank you very much. Jabes Medeiros.

[phil]

Hi Jabes

Yes all versions of IRRICAD take 3D lengths into consideration in the design process and BOM/costing.

Regards

Phil