Irricad

Hi, is there a way to set the starting point for the Google Earth import utility in V.18? The older versions of Irricad saved and started from the last google earth position that was imported. V.18 seems to start at the same location from when it was installed. It would be nice if it I could set the starting point or better if it followed the previously imported position.

Thanks

Corby

This appears to be the case when the image properties are set to 'embed' in the design.
This will be rectified in a future patch.

The IRRICAD Team.

Hi Corby

Version 18 has not changed in this regard. It goes back to the last location in my use. Check to see that it is using the correct IrricadGEImport.ini file. There is a section of this file labelled Start Point.


[StartPoint]
Longitude=-118.634778103001
Latitude=46.068201498433
Zoom=16
MapType=HYBRID

Hi Corby,

This has been rectified in V18.05.
Download this from https://www.irricad.com/download/upgrad ... 195a242d31 . Note that when patching you will just see a “wait while 18.06 configures the system…” message. This will be very quick and V18.06 will be installed seamlessly.

The IRRICAD Team.