Automatic submain flush valve

[Rob Leng]

It would be good to have the option of selecting a submain flush valve for the end(s) of a submain incorporated into the "tape irrigation block" tool along the same lines as is available in the flushing section of this tool.

[Matt Binder]

Rob,
Sounds like a good idea and a great timesaver. It could also be added to the Spray Block Entity also. There could also be an option to show them on the design or just in the BOM as on some plans it may get to conjested with symbols.

[Harvie]

I fully support this idea.
JH

[theohuman]

This sound like a good idea. I would use this in almost every design.
TH

[Gennaro Vellotti]

This sound like a good idea. I would use this in almost every design.
TH

Hey Theo, you can show this as a symbols, but not in the BOM. Same way you add pipe reductions to the design, you can show/add submain flush ends.