Page 1 of 1
Automatic submain flush valve
Posted: Thu Jan 28, 2010 3:41 pm
by Rob Leng
It would be good to have the option of selecting a submain flush valve for the end(s) of a submain incorporated into the "tape irrigation block" tool along the same lines as is available in the flushing section of this tool.
Re: Automatic submain flush valve
Posted: Thu Jan 28, 2010 10:00 pm
by Matt Binder
Rob,
Sounds like a good idea and a great timesaver. It could also be added to the Spray Block Entity also. There could also be an option to show them on the design or just in the BOM as on some plans it may get to conjested with symbols.
Re: Automatic submain flush valve
Posted: Tue Feb 09, 2010 11:45 am
by Harvie
I fully support this idea.
JH
Re: Automatic submain flush valve
Posted: Tue Jan 17, 2023 3:05 pm
by theohuman
This sound like a good idea. I would use this in almost every design.
TH
Re: Automatic submain flush valve
Posted: Mon Apr 17, 2023 7:32 pm
by Gennaro Vellotti
theohuman wrote: ↑Tue Jan 17, 2023 3:05 pm
This sound like a good idea. I would use this in almost every design.
TH
Hey Theo, you can show this as a symbols, but not in the BOM. Same way you add pipe reductions to the design, you can show/add submain flush ends.