"E0003 SuperPro Key Not Found" Message when trying to run New Installation
Posted: Fri Feb 18, 2022 8:45 am
Symptoms:-
1. Look in the Device Manager under “Universal Serial Bus Controllers”
2. If it lists an HL dongle with a warning “update driver” run the SentinelProtectionInstaller7.6.9.exe from the wafer card (located in the “Install” folder) or download from http://www.irricad.com/irricad/download ... r7.6.9.exe.
3. Restart the computer and check the Device Manager - it should now list a SuperPro dongle with no warning messages.
4. Run IRRICAD.
The IRRICAD Team
- On a computer that did not previously have IRRICAD installed
- You were able to successfully activate the hardware key/dongle but upon running IRRICAD you receive the "E0003 SuperPro Key Not Found" message
1. Look in the Device Manager under “Universal Serial Bus Controllers”
2. If it lists an HL dongle with a warning “update driver” run the SentinelProtectionInstaller7.6.9.exe from the wafer card (located in the “Install” folder) or download from http://www.irricad.com/irricad/download ... r7.6.9.exe.
3. Restart the computer and check the Device Manager - it should now list a SuperPro dongle with no warning messages.
4. Run IRRICAD.
The IRRICAD Team