Irricad

Good morning, I'm designing a system with a double line of micro sprinkler, my problem is when I put it to automatically distribute the lines, the first double line doesn't come out double, just a single line, and the last row of double line is not drawn , the rest draws normal .
Attached drawing
Att
Kleber
obs: I made 2 post, because I don't know if you answer in Portuguese

This can happen in some circumstances based on the block properties. The first thing to check is that the "Group Spacing" is greater than the "Lateral Spacing".

If it is, we would like a copy of your design to analyze the cause. Please email to Support@IRRICAD.com.
Additionally, how did you specify the lateral direction?
If it was "Determine Automatically" which boundary did you select?

The IRRICAD Team

GOOD MORNING, THANKS FOR THE RETURN, I WILL BE SENDING AT THIS MOMENT FOR YOUR VERIFICATION ATT KLEBER ZANOTELLO

Thank you for the design, however no spraylines have been laid and therefore it is difficult to know what parameters you used for the placement.
If the teal line is the centre of each group of 2 laterals then please note the "Group Spacing" is not 6.5m, as your plan is labelled, but rather the gap between. As per the dimensions, your "Lateral spacing" is 2.5m then the "Group Spacing" gap is only 4m.

Note that you can also use "User Defined" for the lateral direction to ensure that the laterals start, or align with, a particular existing line or position.

The IRRICAD Team