Close window assign zones to system flow

[Miguel_l_e]

Hi everyone i am having a problem in irricad that has not happened to me before.

I try to open the assign turns section in my system, but when i open it immediately disappears and the window closes and i cannot place the shifts

Regards

[jovivier]

Hi Miguel,

It sounds like you need to upgrade to the latest IRRICAD Version 20 patch, as per our forum post "New Patch for IRRICAD Standalone Version 20" (viewtopic.php?p=2227#p2227).

Does this fix your issue?

The IRRICAD Team

[Miguel_l_e]

hello Jo, thanks for the answer, currently I have version 20.07

[jovivier]

Do you mean that 20.07 is giving this issue?
If so, this might only be related to your design. Have you checked other designs to see if the same issue occurs?
Please send a copy of your design to your local support team.

The IRRICAD Team.

[Miguel_l_e]

yes, i have checked, and the problem persist. I have tried everything you said. Please give me an email to forward my design file.

thanks

[jovivier]

Hi Miguel,

Can you still use the table options? Such as Assign All Zones to One System Flow, Assign Each Zone to a Unique System Flow, and Other Management Options|Assign System Flows to Zones?

The IRRICAD Team

[Miguel_l_e]

Hi Jo,

These options (Assign All Zones to One System Flow, Assign Each Zone to a Unique System Flow, and Other Management Options|Assign System Flows to Zones) also have problems.

[jovivier]

Please send your design to Support@IRRICAD.com.

The IRRICAD Team

[jovivier]

Thank you for your design. The issue was caused by a particular control valve or the connection at that point. Running File|Compress followed by File|Repair fixes it.

The IRRICAD Team

[Miguel_l_e]

Thank you very much Jo, the problem has been solved

Best regards