Hi
In irricad v16 i am trying to use cut lasso to cut tapes in a drain however the beginning of the lasso will not position where the cross hairs are and scrolling the drawing in and out the cut lasso lines do not stay where they were placed.
Thanks
Kyle
Cut Lasso not working
-
turbofergy
- Posts: 37
- Joined: Mon Jul 18, 2016 5:38 pm
- Company: Ferguson Irrigation Solutions and Techno
- City / Town: Bundaberg
-
jovivier
- Site Admin
- Posts: 924
- Joined: Thu Mar 12, 2009 2:57 pm
- Company: Lincoln Agritech Ltd, IRRICAD Software
- City / Town: Lincoln
- Location: Canterbury, New Zealand
- Contact:
Re: Cut Lasso not working
Hi Kyle,
It sounds like you have changed the text size/DPI Scale of your monitor. When the text size is greater than 100% you need to allow for this in IRRICAD. Follow the steps in our forum post Rubberbanding Offset from Pipes / Circular Cursor Incorrect (https://www.irricad.com/phpbb3/viewtopic.php?f=17&t=460).
Note that 18.05 and later automatically adjust for text size / DPI scale.
The IRRICAD Team
It sounds like you have changed the text size/DPI Scale of your monitor. When the text size is greater than 100% you need to allow for this in IRRICAD. Follow the steps in our forum post Rubberbanding Offset from Pipes / Circular Cursor Incorrect (https://www.irricad.com/phpbb3/viewtopic.php?f=17&t=460).
Note that 18.05 and later automatically adjust for text size / DPI scale.
The IRRICAD Team