Hi Team,
Yes the "Update Entities From Database" checkbox is checked.
I believe IrriCAD stores some design specific database information within the .dwg file in the past is may have been in one of the support files (.cer .des .dzf .dzn .iar .bdb .stn .vcd .wsp .zne .ztm). If this is the case, it ...
Search found 3 matches
- Fri Aug 22, 2025 6:04 pm
- Forum: Databases and Materials Selection
- Topic: Outlet Plotting Symbol
- Replies: 3
- Views: 173
- Wed Aug 20, 2025 11:42 am
- Forum: Databases and Materials Selection
- Topic: Outlet Plotting Symbol
- Replies: 3
- Views: 173
Outlet Plotting Symbol
Hi Team,
I am working on a design where I need to change the Outlet "Plotting Symbol" as the line width is too small to see. After i make the change to the .dwg file used for the outlet, only new outlets placed are affected by the change, where the original symbols within the design don't. Is there ...
I am working on a design where I need to change the Outlet "Plotting Symbol" as the line width is too small to see. After i make the change to the .dwg file used for the outlet, only new outlets placed are affected by the change, where the original symbols within the design don't. Is there ...
- Mon Jul 14, 2025 1:40 pm
- Forum: Hydraulic Design
- Topic: Pivot Module in Link Issue
- Replies: 2
- Views: 760
Pivot Module in Link Issue
Hi Team,
I have started using the Pivot Module in Link (v21.23.34) and have had a 100% failure rate in completing a successful pivot design. The module
will allow for the placement of a pivot and accept data inputs, but any changes or annilius causes major issues that require the design to be ...
I have started using the Pivot Module in Link (v21.23.34) and have had a 100% failure rate in completing a successful pivot design. The module
will allow for the placement of a pivot and accept data inputs, but any changes or annilius causes major issues that require the design to be ...