Zone Flush Reports

[Jim Phillips]

Hi Jo,
Can IrriCAD generate a report on Zone Flushing that is a collation of all of the analysis of the manifold flushing reports.
As I do the individual manifold analysis, the data for that manifold comes up in the Zone Flushing Report. Once I do a manifold I save it so that I can refer to it at a later for mainline sizing and pump selection.
It would be time saving if as I did the flushing analysis, the information concerning that zone and manifold could be collated into a single report as follows:
Zone1, Manifold 1 - Manifold Flushing Total Flow 00.00l/s - Manifold End Flush Flow 00.00l/s
Zone1, Manifold 2 - Manifold Flushing Total Flow 00.00l/s - Manifold End Flush Flow 00.00l/s
And so on through the Zones and the manifolds.

My need for this is to assess the pump duty relevent to the highest zone demand under flushing conditions. This affects the choice of pump and the sizing of the mainline.
What I currently do is go through the Zone Flushing list, choose the manifold and zone with the highest demand then do my mainline design. T
It is time consuming to go through the list as it currently is when at times I have a large number of Zones and Flushing Manifolds.

Thanks
Jim Phillips