No elements in row of f, refer to manual

[Miguel_l_e]

Hi all, I have the next problem, when calculating the main line, I get the following message (No elements in row of f, refer to manual) (DES 459), I have reviewed all the connections of valves and all are connected, please help.

regards

Miguel

[SerG]

Hi Miguel,

Irricad's help topics says:

DES 459 : No elements in row of F
Zone control valves not connected to a water supply usually causes this message. To check run Design|Check Outlet Connectivity. This will identify any problems of this nature. If all valves are connected to at least one water supply, try changing the configuration of the system, or manually specifying some pipe sizes. Check the management to ensure the valves are connected to the water supply specified to operate that system flow.

If any of the above messages occur and the reason for the problem cannot be found, save the design and contact your service agent or AEI Software.

I hope this is helpful to you.

[Miguel_l_e]

I already try and not work

[jovivier]

Mare sure your management is correct. If you have multiple water supplies that are not supplying the same valves then if you have assigned a water supply to supply a system flow it is not connected to this message can occur. If you use graphical management (Assign Zones to System Flows) the system flow numbers appear on each water supply which you can then check that those system flows are zones physically attached to that water supply. If you are still having difficulty please email the design to your local support team or Support@IRRICAD.com.