If receive message: "Attempted an unsupported operation" in Database Editor

[jovivier]

If receive message: "Attempted an unsupported operation" in Database Editor

If you receive a message that says "Attempted an unsupported operation" when running the Database Editor this is caused by the
TeeChart8.ocx control either missing or not being registered on your computer for the new installation or upgrade.
This will affect the Curve Fit utility in the Database Editor.

1. First check that the TeeChart file is present in your installed IRRICAD folder, commonly located in C:\Program Files\Irricad\Irricad Link xxxCAD\Database. If you are unsure of the path then right-click on the IRRICAD Link Databases icon on the desktop to see the location on your system. For example:-

DatabasePath.png

If the ocx file is not present you should find it in your anti-virus quarantine where it can usually be restored from and an exclusion/exception set in your anti-virus for this file. If you cannot restore it download the file from http://www.irricad.com/irricad/download ... Chart8.zip, save the zip file to your hard-drive, and unzip the contents into your installed Irricad Link folder. (Note you may need to tell you browser it is safe, or to 'keep' the file).


2. If the TeeChart file is present in the Irricad folder then the cause is that it did not register on your computer upon installation or was deregistered in some way. Reasons for this could be limited privileges when installing IRRICAD or another program interfering during the installation. (It is always a good idea to turn off other programs and even your anti-virus software during the installation process).

You can register this file manually.

a. Log in as Administrator.
b. Run a Command Prompt by searching for cmd and then right-click on cmd.exe and select Run as Administrator.
A DOS window will open up.
c. Now type in cd C:\ <enter>
cd program files <enter>
cd irricad <enter>
cd Irricad Link xxxCAD<enter> - enter the correct CAD platform - i.e. AutoCAD or BricsCAD
(note type in the correct Irricad folder path name for where your Link version is installed)
cd database <enter>
regsvr32 TeeChart8.ocx<enter>

It should tell you that TeeChart8.ocx is now registered successfully. This will not fix the Hydraulic Gradeline issue as this uses TeeChart201664.ocx. See our forum post http://www.irricad.com/phpbb3/viewtopic ... =666#p1552 for steps on how to fix this.
Top