Hello everyone,
I hope you have a wonderful year ahead.
I need assistance with exporting a DEZ file from IrriCAD Stand Alone to a DAZ IrriCAD Link file format. I successfully exported the file, but when I import it into IrriCAD Link, I receive the following error message: "WARNING - INPT 100, Unit Mismatch. The insertion unit for the document (ft) does not match the IrriCAD distance unit (m)." Subsequently, IrriCAD Link crashes. The IrriCAD Stand Alone units have been set to meters.
Thank you.
Units error...
-
jovivier
- Site Admin
- Posts: 919
- Joined: Thu Mar 12, 2009 2:57 pm
- Company: Lincoln Agritech Ltd, IRRICAD Software
- City / Town: Lincoln
- Location: Canterbury, New Zealand
- Contact:
Re: Units error...
Hi Pancho,
In IRRICAD Standalone check Settings|Import/Export Settings.
The dialog will display the "Import Settings" and the "Export Settings".
For the "Export Settings" is the "Base Export Unit" set to Feet?
If so, change this option to Meter and export to .Daz file again.
If this does not solve the issue you can send the original IRRICAD .Dez file and the .Daz file to your local support team for additional support.
The IRRICAD Team
In IRRICAD Standalone check Settings|Import/Export Settings.
The dialog will display the "Import Settings" and the "Export Settings".
For the "Export Settings" is the "Base Export Unit" set to Feet?
If so, change this option to Meter and export to .Daz file again.
If this does not solve the issue you can send the original IRRICAD .Dez file and the .Daz file to your local support team for additional support.
The IRRICAD Team