I have a design nearly completed and I want to see the total dynamic head of the system is there a report for this?
I imported elevation data is there a spot where I can see the slope that the program calculated?
Thank you,
Robert
Total Dynamic Head and slope information
-
jovivier
- Site Admin
- Posts: 919
- Joined: Thu Mar 12, 2009 2:57 pm
- Company: Lincoln Agritech Ltd, IRRICAD Software
- City / Town: Lincoln
- Location: Canterbury, New Zealand
- Contact:
Re: Total Dynamic Head and slope information
Robert,
The total dynamic head cannot be shown directly. However from the reports you can calculate the difference between the required water supply pressure minus the outlet or valve pressure for each outlet/valve position.
For a graphical view you can use the Hydraulic Gradeline located in the Reports menu and turn the elevation view on or off.
For zone select a lateral, section of submain or a zone pipe.
For mainline select the mainline path required - do not include branches.
Regards,
Jo
The total dynamic head cannot be shown directly. However from the reports you can calculate the difference between the required water supply pressure minus the outlet or valve pressure for each outlet/valve position.
For a graphical view you can use the Hydraulic Gradeline located in the Reports menu and turn the elevation view on or off.
For zone select a lateral, section of submain or a zone pipe.
For mainline select the mainline path required - do not include branches.
Regards,
Jo