Good evening.
I recently changed my computer and I'm having some trouble setting it up.
On my old computer I was able to set labels to a reasonable size, some overlapped and I had to manually correct them, which was great.
Now I can't set labels on short sections, for example in the attachment, 34 meters.
How can I set it up to go back to how it was before?
configure label
-
JP.Oliveira
- Posts: 6
- Joined: Wed Feb 15, 2023 3:21 am
- Company: Bolsa Irriga/Netafim
- City / Town: FRANCA
- Product: Irricad Standalone
configure label
You do not have the required permissions to view the files attached to this post.
-
jovivier
- Site Admin
- Posts: 919
- Joined: Thu Mar 12, 2009 2:57 pm
- Company: Lincoln Agritech Ltd, IRRICAD Software
- City / Town: Lincoln
- Location: Canterbury, New Zealand
- Contact:
Re: configure label
Good evening.
I suggest to check the following options in Settings|Labels:-
- if the "Check label length" option is enabled. Uncheck this setting. It is likely that the label is longer than the pipe / combined pipes and therefore won't be created.
- the "Angle tolerance" field. The default is only 5 degrees and this may be exceeded by the curve of your submain. Enter a higher tolerance angle if required.
The IRRICAD Team
I suggest to check the following options in Settings|Labels:-
- if the "Check label length" option is enabled. Uncheck this setting. It is likely that the label is longer than the pipe / combined pipes and therefore won't be created.
- the "Angle tolerance" field. The default is only 5 degrees and this may be exceeded by the curve of your submain. Enter a higher tolerance angle if required.
The IRRICAD Team