Irricad

Good evening.
I recently changed my computer and I'm having some trouble setting it up.

On my old computer I was able to set labels to a reasonable size, some overlapped and I had to manually correct them, which was great.

Now I can't set labels on short sections, for example in the attachment, 34 meters.

How can I set it up to go back to how it was before?

Good evening.

I suggest to check the following options in Settings|Labels:-
- if the "Check label length" option is enabled. Uncheck this setting. It is likely that the label is longer than the pipe / combined pipes and therefore won't be created.
- the "Angle tolerance" field. The default is only 5 degrees and this may be exceeded by the curve of your submain. Enter a higher tolerance angle if required.

The IRRICAD Team