Occasionally you may detect, via the reports, a short length pipe that you wish to change or delete. Locating the errant pipe on the plan can sometimes be difficult so here are a set of steps to help:-
1. Go to Zone or Mainline|Pipe and draw an example of the errant pipe outside the design area.
2. Select All. Use Change Type.
3. Click on the pipe you have just drawn.
4. Change the line width to 15 and click OK.
5. Enable Match on "Pipe" and Change on "Line Width" in the Match/Change dialog and click OK.
You should now find it easier to locate the pipe on the plan.
Note that if the errant pipe has only been used as riser then it will appear in the materials list but not in the legend on the Plot Layout.