Irricad

Im having trouble with Irricad verion 12.02 running on Windows 7 32 bit.
Currently i am using Irricad to clean up GPS data i have taken (mostly lines and polygons), and often they are imported as a "generic_lines" layer.
My issue arises when i create a new layer and want to move certain data from the generic layer to the newly created layer.
I use the change function but instead of moving it to the layer i selected it instead sends it to an "IRRICAD" layer.

After restarting IRRICAD several times i can usually get it to do what i want but its a very annoying and time consuming process.

Any idea whats going on or what im doing wrong?

Hi,

The issue was due to a change in V12.02 with the Layer Bar (which can now be ordered on name, visibility or printability). After creating a new layer go into Settings|Layers and click OK. Now you can move items to the new layer. Later patches fix this issue. Patch 12.12 is available to be installed over V12.02, however, you are eligible for Version 13. Go to http://www.irricad.com/irricadpro/irric ... e-upgrades and download and install the V12-V13Upgrade and then apply the V1320 patch. I believe the dongle you are using has already been enabled for Version 13.