Hello All
Setting out a block in Link. When i put in a cut pipe for a sub main the nodes are getting very large negative Z values (-1000000.00). I am not sure where they are coming from. When i look at the 3D DEM the heights are are all correct. is there a way to correct this
Regards
Kyle
Irricad Link - Large Negative Z values
-
turbofergy
- Posts: 37
- Joined: Mon Jul 18, 2016 5:38 pm
- Company: Ferguson Irrigation Solutions and Techno
- City / Town: Bundaberg
-
jovivier
- Site Admin
- Posts: 919
- Joined: Thu Mar 12, 2009 2:57 pm
- Company: Lincoln Agritech Ltd, IRRICAD Software
- City / Town: Lincoln
- Location: Canterbury, New Zealand
- Contact:
Re: Irricad Link - Large Negative Z values
Hi Kyle,
In IRRICAD Link the Z value may not be set (-100000.00) or may be set to 0.0 for IRRICAD items. However, if elevations are present and able to be used in the hydraulic design then the "Elevation" is specified in the Object Info dialog as follows:-
The IRRICAD Team
In IRRICAD Link the Z value may not be set (-100000.00) or may be set to 0.0 for IRRICAD items. However, if elevations are present and able to be used in the hydraulic design then the "Elevation" is specified in the Object Info dialog as follows:-
The IRRICAD Team
You do not have the required permissions to view the files attached to this post.