Irricad

Hello All

Setting out a block in Link. When i put in a cut pipe for a sub main the nodes are getting very large negative Z values (-1000000.00). I am not sure where they are coming from. When i look at the 3D DEM the heights are are all correct. is there a way to correct this

Regards

Kyle

Hi Kyle,

In IRRICAD Link the Z value may not be set (-100000.00) or may be set to 0.0 for IRRICAD items. However, if elevations are present and able to be used in the hydraulic design then the "Elevation" is specified in the Object Info dialog as follows:-
The IRRICAD Team