How can I edit the reported Length/Number ?
Example, some of the drip tapes are reported in rolls and I would like them reported in ft.
Thanks
Edit units in BOM Report
-
garrett.carlson
- Posts: 2
- Joined: Fri Feb 10, 2023 2:22 am
- Company: Irrigation-Mart
- City / Town: Ruston
- Product: Irricad Standalone
Edit units in BOM Report
You do not have the required permissions to view the files attached to this post.
-
jovivier
- Site Admin
- Posts: 919
- Joined: Thu Mar 12, 2009 2:57 pm
- Company: Lincoln Agritech Ltd, IRRICAD Software
- City / Town: Lincoln
- Location: Canterbury, New Zealand
- Contact:
Re: Edit units in BOM Report
In Design|Pipe Fitting Matching Table the specific pipe type has been set to "Roll/Length" by inserting the number of ft or m in each length or roll. Simply set this number back to 0.0.
Note that only Bill of Materials reports will include the "Rounding" and "Roll/Length" values. By design, the Costing reports will display only the raw (3D) length in ft or m. In this way you can leave the "Rounding" and "Roll/Length" values if required.
The IRRICAD Team
Note that only Bill of Materials reports will include the "Rounding" and "Roll/Length" values. By design, the Costing reports will display only the raw (3D) length in ft or m. In this way you can leave the "Rounding" and "Roll/Length" values if required.
The IRRICAD Team