Irricad

How can I edit the reported Length/Number ?


Example, some of the drip tapes are reported in rolls and I would like them reported in ft.

Thanks

In Design|Pipe Fitting Matching Table the specific pipe type has been set to "Roll/Length" by inserting the number of ft or m in each length or roll. Simply set this number back to 0.0.

Note that only Bill of Materials reports will include the "Rounding" and "Roll/Length" values. By design, the Costing reports will display only the raw (3D) length in ft or m. In this way you can leave the "Rounding" and "Roll/Length" values if required.

The IRRICAD Team