Irricad

I am experiencing a problem in an IrriCAD Link design. Design is laid out normally but the mainline pipes won't connect. Any thoughts?

Thanks, Toggling and IM have worked a treat.

My crosshairs suddenly went from 90 degrees on the screen to 45 degrees and acted orthographically. how do I turn this off?

In a large design I am having trouble getting IrriCAD to select the zones I want for a given water supply. It works up so far then keeps defaulting the previous allocate zone to zero. Is there a way to nominate in the "Assign Zones to System Flows" box to enter say Zones 1 - 30 on Water Su...

Hi Jo, Can IrriCAD generate a report on Zone Flushing that is a collation of all of the analysis of the manifold flushing reports. As I do the individual manifold analysis, the data for that manifold comes up in the Zone Flushing Report. Once I do a manifold I save it so that I can refer to it at a ...

Thanks Dan

How can I label a section of pipe so that the label is inclined 45 degrees to the line of the pipe? I used to be able to do in in Settings, labels etc but this does not appear to work anymore.

Thanks Jo, works a treat

Thanks to Gennaro for solving a problem for me on New Years eve. I had imported a dwg, (big co-ordinate numbers) file in to IrriCAD and not corrected my x/y co-ordinates in IrriCAD. The effect of this on IrriCAD was dramatic, I thought I had a virus, total chaos. Note to self to always check co-ordi...

I am doing a unusually shaped landscape design that requires me to individually place sprinklers and valves. In doing this I am also manually selecting the zones for flow and location. This all calculates well with no problems. What I would like to be able to access is the "Management Report&qu...

IrriCAD13 is driving me nuts. It has worked great for about 6 months, bit unstable but manageable. I am using Windows 8.1 and in the last week have had some major issues. The ute file vanished. Today it is the above AVIS2D.ocx. I have tried the memo from Jo to no avail. What is going on? I have unin...

I have a design with a 75 metre variation in elevation. not all in one block but spread out over a range of blocks. The most a single bloc falls is about 15 metres. The zone design fits into the pressure parameters quite well (PC design)in velocity design and having multiple lateral and submain size...

Thanks Jo.

I am doing a park pop up design. I am working my way through the various differing turf and garden areas one at a time and as I locate the sprinklers, connect them up I then add them to the zone count. (Assign System Flows) I then do an LP design, Valve analysis and a mainline design and get a good ...

Thanks Jo, have got it working with a bit of input from Kosi.

Rgds

Jim P :

I am doing a design with 3 independent water supplies. How do I enter the data to have n*IrriCAD size each mainline and sytem duty. The mains are not connected to each other, all supply their own zones

Thanks Kosi and Jo, I am away and wont be back until Friday however, I have tried the compatibility mode without success. When I get back I will try the solution suggested by Kosi. In answer to your questions Jo, I can copy and send the "unexpected problem" report. Yes, once I have re-inst...

Hi Jo, Having a bit of grief with the Winicad.exe file. My power supply died a few weeks ago, had it replaced, all good. The problem is that when I go to open IrriCAD a message comes up saying IrriCAD has encountered an unexpected problem and needs to shut down. By uninstalling and re-installing Irr...